what is an renewable energy? Renewable energy is energy generated from natural resources—such as sunlight, wind, rain, tides and geothermal heat—which are renewable (naturally replenished). In 2006, about 18% of global final energy consumption came from renewables, with 13% coming from traditional biomass, such as wood-burning. Hydroelectricity was the next largest renewable source, providing 3% (15% of global electricity generation),[1] followed by solar hot water/heating, which contributed 1.3%. Modern technologies, such as geothermal energy, wind power, solar power, and ocean energy together provided some 0.8% of final energy consumption. The energy of the wind Airflows can be used to run wind turbines. Modern wind turbines range from around 600 kW to 5 MW of rated power, although turbines with rated output of 1.5–3 MW have become the most common for commercial use; the power output of a turbine is a function of the cube of the wind speed, so as wind speed increases, power output increases dramatically.[16] Areas where winds are stronger and more constant, such as offshore and high altitude sites, are preferred locations for wind farms. Since wind speed is not constant, a wind farm's annual energy production is never as much as the sum of the generator nameplate ratings multiplied by the total hours in a year. The ratio of actual productivity in a year to this theoretical maximum is called the capacity factor. Typical capacity factors are 20-40%, with values at the upper end of the range in particularly favourable sites.[17][18] For example, a 1 megawatt turbine with a capacity factor of 35% will not produce 8,760 megawatt-hours in a year, but only 0.35x24x365 = 3,066 MWh, averaging to 0.35 MW. Online data is available for some locations and the capacity factor can be calculated from the yearly output.[19][20] Globally, the long-term technical potential of wind energy is believed to be five times total current global energy production, or 40 times current electricity demand. This could require large amounts of land to be used for wind turbines, particularly in areas of higher wind resources. Offshore resources experience mean wind speeds of ~90% greater than that of land, so offshore resources could contribute substantially more energy.[21] This number could also increase with higher altitude ground-based or airborne wind turbines.[22] Wind power is renewable and produces no greenhouse gases during operation, such as carbon dioxide and methane. Energy in water (in the form of kinetic energy, temperature differences or salinity gradients) can be harnessed and used. Since water is about 800 times denser than air even a slow flowing stream of water, or moderate sea swell, can yield considerable amounts of energy.There are many forms of water energy: · Hydroelectric energy is a term usually reserved for large-scale hydroelectric dams. Examples are the Grand Coulee Dam in Washington State and the Akosombo Dam in Ghana. · Micro hydro systems are hydroelectric power installations that typically produce up to 100 kW of power. They are often used in water rich areas as a Remote Area Power Supply (RAPS). There are many of these installations around the world, including several delivering around 50 kW in the Solomon Islands. · Damless hydro systems derive kinetic energy from rivers and oceans without using a dam. · Ocean energy describes all the technologies to harness energy from the ocean and the sea: · Marine current power. Similar to tidal stream power, uses the kinetic energy of marine currents · Ocean thermal energy conversion (OTEC) uses the temperature difference between the warmer surface of the ocean and the colder lower recesses. To this end, it employs a cyclic heat engine. OTEC has not been field-tested on a large scale.· Tidal power captures energy from the tides. Two different principles for generating energy from the tides are used at the moment: 1. Tidal motion in the vertical direction — Tides come in, raise water levels in a basin, and tides roll out. Around low tide, the water in the basin is discharged through a turbine, exploiting the stored potential energy. 2. Tidal motion in the horizontal direction — Or tidal stream power. Using tidal stream generators, like wind turbines but then in a tidal stream. Due to the high density of water, about eight-hundred times the density of air, tidal currents can have a lot of kinetic energy. Several commercial prototypes have been build, and more are in development. · Wave power uses the energy in waves. Wave power machines usually take the form of floating or neutrally buoyant structures which move relative to one another or to a fixed point. Wave power has now reached commercialization. · Osmotic power or salinity gradient power, is the energy retrieved from the difference in the salt concentration between seawater and river water. Reverse electrodialysis (PRO) is in the research and testing phase. · Vortex power is generated by placing obstacles in rivers in order to cause the formation of vortices which can then be tapped for energy.Deep lake water cooling, although not technically an energy generation method, can save a lot of energy in summer. It uses submerged pipes as a heat sink for climate control systems. Lake-bottom water is a year-round local constant of about 4 °C. Solar energy use In this context, "solar energy" refers to energy that is collected from sunlight. Solar energy can be applied in many ways, including to: · Generate electricity using photovoltaic solar cells. · Generate electricity using concentrated solar power. · Generate electricity by heating trapped air which rotates turbines in a Solar updraft tower. · Generate electricity in geosynchronous orbit using solar power satellites. · Generate hydrogen using photoelectrochemical cells.· Heat and cool air through use of solar chimneys. · Heat buildings, directly, through passive solar building design. · Heat foodstuffs, through solar ovens. · Heat water or air for domestic hot water and space heating needs using solar-thermal panels.Solar air conditioning BioFuel Plants use photosynthesis to grow and produce biomass. Also known as biomatter, biomass can be used directly as fuel or to produce biofuels. Agriculturally produced biomass fuels, such as biodiesel, ethanol and bagasse (often a by-product of sugar cane cultivation) can be burned in internal combustion engines or boilers. Typically biofuel is burned to release its stored chemical energy. Research into more efficient methods of converting biofuels and other fuels into electricity utilizing fuel cells is an area of very active work. Liquid biofuel Liquid biofuel is usually either a bioalcohol such as ethanol fuel or an oil such as biodiesel or straight vegetable oil. Biodiesel can be used in modern diesel vehicles with little or no modification to the engine. It can be made from waste and virgin vegetable and animal oils and fats (lipids). Virgin vegetable oils can be used in modified diesel engines. In fact the diesel engine was originally designed to run on vegetable oil rather than fossil fuel. A major benefit of biodiesel use is the reduction in net CO2 emissions, since all the carbon emitted was recently captured during the growing phase of the biomass. The use of biodiesel also reduces emission of carbon monoxide and other pollutants by 20 to 40%. In some areas corn, cornstalks, sugarbeets, sugar cane, and switchgrasses are grown specifically to produce ethanol (also known as grain alcohol) a liquid which can be used in internal combustion engines and fuel cells. Ethanol is being phased into the current energy infrastructure. E85 is a fuel composed of 85% ethanol and 15% gasoline that is sold to consumers. Biobutanol is being developed as an alternative to bioethanol. There is growing international criticism of the production of biofuel crops in association with food crops with respect to issues such as food security, environmental impacts (deforestation) and energy balance. Another source of biofuel is sweet sorghum. It produces both food and fuel from the same crop. Some studies have shown that the crop is net energy positive ie. it produces more energy than is consumed in its production and utilization. Solid biomass Solid biomass is mostly commonly usually used directly as a combustible fuel, producing 10-20 MJ/kg of heat. Its forms and sources include wood fuel, the biogenic portion of municipal solid waste, or the unused portion of field crops. Field crops may or may not be grown intentionally as an energy crop, and the remaining plant byproduct used as a fuel. Most types of biomass contain energy. Even cow manure still contains two-thirds of the original energy consumed by the cow. Energy harvesting via a bioreactor is a cost-effective solution to the waste disposal issues faced by the dairy farmer, and can produce enough biogas to run a farm. With current technology, it is not ideally suited for use as a transportation fuel. Most transportation vehicles require power sources with high power density, such as that provided by internal combustion engines. These engines generally require clean burning fuels, which are generally in liquid form, and to a lesser extent, compressed gaseous phase. Liquids are more portable because they can have a high energy density, and they can be pumped, which makes handling easier. Non-transportation applications can usually tolerate the low power-density of external combustion engines, that can run directly on less-expensive solid biomass fuel, for combined heat and power. One type of biomass is wood, which has been used for millennia. Two billion people currently cook every day, and heat their homes in the winter by burning biomass, which is a major contributor to man-made climate change global warming. The black soot that is being carried from Asia to polar ice caps is causing them to melt faster in the summer. In the 19th century, wood-fired steam engines were common, contributing significantly to industrial revolution unhealthy air pollution. Coal is a form of biomass that has been compressed over millennia to produce a non-renewable, highly-polluting fossil fuel. Wood and its byproducts can now be converted through processes such as gasification into biofuels such as woodgas, biogas, methanol or ethanol fuel; although further development may be required to make these methods affordable and practical. Sugar cane residue, wheat chaff, corn cobs and other plant matter can be, and are, burned quite successfully. The net carbon dioxide emissions that are added to the atmosphere by this process are only from the fossil fuel that was consumed to plant, fertilize, harvest and transport the biomass. Processes to harvest biomass from short-rotation trees like poplars and willows and perennial grasses such as switchgrass, phalaris, and miscanthus, require less frequent cultivation and less nitrogen than do typical annual crops. Pelletizing miscanthus and burning it to generate electricity is being studied and may be economically viable. Geothermal energy Geothermal energy is energy obtained by tapping the heat of the earth itself, usually from kilometers deep into the Earth's crust. It is expensive to build a power station but operating costs are low resulting in low energy costs for suitable sites. Ultimately, this energy derives from heat in the Earth's core. Three types of power plants are used to generate power from geothermal energy: dry steam, flash, and binary. Dry steam plants take steam out of fractures in the ground and use it to directly drive a turbine that spins a generator. Flash plants take hot water, usually at temperatures over 200 °C, out of the ground, and allows it to boil as it rises to the surface then separates the steam phase in steam/water separators and then runs the steam through a turbine. In binary plants, the hot water flows through heat exchangers, boiling an organic fluid that spins the turbine. The condensed steam and remaining geothermal fluid from all three types of plants are injected back into the hot rock to pick up more heat. The geothermal energy from the core of the Earth is closer to the surface in some areas than in others. Where hot underground steam or water can be tapped and brought to the surface it may be used to generate electricity. Such geothermal power sources exist in certain geologically unstable parts of the world such as Chile, Iceland, New Zealand, United States, the Philippines and Italy. The two most prominent areas for this in the United States are in the Yellowstone basin and in northern California. Iceland produced 170 MW geothermal power and heated 86% of all houses in the year 2000 through geothermal energy. Some 8000 MW of capacity is operational in total. There is also the potential to generate geothermal energy from hot dry rocks. Holes at least 3 km deep are drilled into the earth. Some of these holes pump water into the earth, while other holes pump hot water out. The heat resource consists of hot underground radiogenic granite rocks, which heat up when there is enough sediment between the rock and the earths surface. Several companies in Australia are exploring this technology.